萬盛學電腦網

您现在的位置: 萬盛學電腦網 >> 網路安全 >  >> 網路應用技術 >> 應用程式教學

Cisco AIR-AP1131AG 無線 AP 基礎配置全攻略:從恢復出廠到 WPA2-PSK 部署

Cisco Aironet 1131AG 是經典的企業級無線接入點,支援 802.11a/g 雙頻。本文以實戰角度,詳細記錄從 Console 線連接、恢復出廠、配置管理 IP、啟用 Web 管理、到完成 WPA2-PSK 無線加密的完整流程,並附上最終運行配置供參考。

一、恢復出廠設置

  1. 滑開前蓋,按住 MODE 鍵不放。
  2. 接通電源,待 Ethernet 指示燈 變為橙紅色(琥珀色)時鬆開。
  3. 設備重啟後自動恢復出廠值:無 IP、無線關閉、預設用戶名 ap、密碼 Cisco(C 大寫)。

注意:此時只能通過 Console 口(9600,8,N,1)進行初始配置。

二、配置管理 IP(BVI 1 接口)

BVI(Bridge-Group Virtual Interface)將有線、無線接口橋接至同一 IP,便於管理。

ap> en
Password: Cisco
ap# conf t
ap(config)# interface bvi 1
ap(config-if)# ip address 10.10.0.10 255.255.255.0
ap(config-if)# no shutdown
ap(config-if)# exit
ap(config)# end
ap# copy run start

三、啟用 Web 管理並修改預設憑證

  1. 瀏覽器訪問 https://10.10.0.10,預設用戶名/密碼均為 cisco(C 大寫)。
  2. Express Set-Up:修改 Hostname、IP 地址,點擊 Apply。
  3. Security → Admin Access:務必先設置強密碼,防止未授權訪問。

四、啟用雙頻無線(802.11g / 802.11a)

  1. Network Interfaces → Radio0-802.11G:Enable Radio → 選擇頻道 → Apply。
  2. 同樣操作啟用 Radio1-802.11A。

五、配置 WPA2-PSK (AES CCMP + TKIP) 加密

  1. Security → Encryption Manager:Encryption Mode 選 Cipher: AES CCMP + TKIP → Apply-All 應用到所有 Radio。
  2. Security → SSID Manager → New:輸入 SSID 名稱,勾選 Radio0-802.11G 與 Radio0-802.11A。
  3. Key Management:Mandatory;Enable WPA:WPAv2;輸入 WPA Pre-shared Key(8-63 字元)。
  4. Guest Mode / Infrastructure SSID Settings:分別將 802.11G 與 802.11A 的 Single Guest Mode SSID 設為新建 SSID → Apply。

六、完整運行配置參考

version 12.4
hostname myap
enable secret 5 $1$HEM4$4xBQt1xZCkFBAga1R6tJ8/
username root secret 5 $1$b9X9$KPWjv8hjKogY1335G/7QM1
bridge irb
!
dot11 ssid SOLVAY
 authentication open
 authentication key-management wpa version 2
 guest-mode
 wpa-psk ascii 7 0605062F424B1D485744465E5A
!
interface Dot11Radio0
 encryption mode ciphers aes-ccm tkip
 ssid SOLVAY
 channel 2462
 station-role root
 bridge-group 1
 bridge-group 1 subscriber-loop-control
 bridge-group 1 block-unknown-source
 no bridge-group 1 source-learning
 no bridge-group 1 unicast-flooding
 bridge-group 1 spanning-disabled
!
interface Dot11Radio1
 encryption mode ciphers aes-ccm tkip
 ssid SOLVAY
 channel 5745
 station-role root
 bridge-group 1
 bridge-group 1 subscriber-loop-control
 bridge-group 1 block-unknown-source
 no bridge-group 1 source-learning
 no bridge-group 1 unicast-flooding
 bridge-group 1 spanning-disabled
!
interface FastEthernet0
 bridge-group 1
!
interface BVI1
 ip address 10.10.0.10 255.255.255.0
!
ip http server
no ip http secure-server
bridge 1 route ip
line con 0
line vty 0 4
 login local
end

七、關鍵提醒

  • 配置完成後務必 copy run start 保存,斷電不丟失。
  • 生產環境建議關閉 HTTP,啟用 ip http secure-server 使用 HTTPS 管理。
  • 定期備份配置文件,便於設備替換快速恢復。
copyright © 萬盛學電腦網 all rights reserved